7. Operations

Working with Groups

tçêâáåÖ=ïáíÜ=dêçìéë

Group

1

A Group is a single button that represents a certain number of destinations, as programmed by the user. For example, the Group 1 button can represent destination 1 or destinations 1, 2 and 3.

On the Controller SC, 4 group buttons are available.

On the Controller LC, 8 group buttons are available.

Groups are activated by pressing (lighting) the desired Group button. With groups activated, your setups and “looks” will be routed to the selected destinations only. Any combination of Group buttons can be enabled, but all group selections (whether individual or multiple) are mutually exclusive.

The following topics are discussed in this section:

Learning a Group

Adding or Removing Destinations from a Group

Activating a Group

Clearing a Group

Unlearning a Group

Group Notes

iÉ~êåáåÖ=~=dêçìé

„Use the following steps to learn (program) a group button:

Note

1.Controller LC:

By default, only Group 1 is assigned to Destination 1. All other groups must be defined by the user.

a.On the Destination Bus, activate the desired destination(s).

b.Press and hold Learn.

c.Press the desired Group button.

Note

2.Controller SC:

This method can also be used to add (or remove) destinations to/from the group — simply by re-learning the button with a new array of destinations.

a.Press and hold the desired Group button.

b.On the Destination Bus, press the desired destination button(s).

c.Release the Group button.

Note

This method also works on the Controller LC.

312

 

Encore Presentation System • User’s Guide • Rev 04

 

Page 312
Image 312
Barco 26-0313000-00 manual TçêâáåÖ=ïáíÜ=dêçìéë, IÉ~êåáåÖ=~=dêçìé