Barco 26-0313000-00 manual Ìñ=aÉëíáå~íáçå=pÉíìé=kçíÉë

6. System Setup

AUX Destination Setup

11.In the SDI section:

a.On the SDI Router Name line, select the router from which SDI sources will be routed to the ImagePRO (or PrePRO-II).

b.On the SDI Router Output line, select the specific router output that you designated as an Aux output.

c.On the ImagePRO Input (or PrePRO-II Input) line, select the ImagePRO or PrePRO-II input to which the SDI router output is connected.

12.In the DVI section (applies to ImagePRO Aux destinations only):

a.On the DVI Router Name line, select the router from which DVI sources will be routed to the ImagePRO.

b.On the DVI Router Output line, select the specific router output that you designated as an Aux output.

c.On the ImagePRO Input line, select the ImagePRO input to which the DVI router output is connected.

13.Press {BACK} to return to the Destination Setup Menu.

14.Repeat from step 5 to configure another ImagePRO or PrePRO-II Aux destination.

15.Press {BACK} to return to the System Menu.

16.In the System Keypad, press SAVE to save the new system configuration.

This completes the procedure for defining ImagePRO or PrePRO-II Aux destinations. The selected button(s) on the Destination Bus are now active.

^ìñ=aÉëíáå~íáçå=pÉíìé=kçíÉë

Please note the following important points regarding Aux Destination Setup:

•ImagePRO and PrePRO-II output setups must be performed locally on the units themselves.

•Only one router of each type (Analog, DVI and SDI) can be connected to an ImagePRO unit.

•In order to ensure that the ImagePRO and PresentationPRO-II units properly process each input, an Input Configuration File must be created for each input. This function is accomplished with the Controller’s automatic “Copy Down” feature, which is initiated by setting up your Processor and ScreenPRO-II inputs. As you progress through the entire setup sequence, ensure that you complete the “Input Setup” procedure on page 293 to guarantee a “Copy Down.”

Note

In general, a “Copy Down” takes place automatically to all destinations that are currently defined to be connected to a given router.

284 Encore Presentation System • User’s Guide • Rev 04