Barco 26-0313000-00 manual Encore Presentation System User’s Guide Rev 189

5. Menu Orientation

System Menu

•Router Input — Applies to Router connections — selects the router input that you wish to associate with the source. The range depends on the number of inputs defined in the Router Specification Menu.

Note

The same router input can be chosen for different source numbers.

•ID — Applies to direct connections — this option selects the ID of the selected Encore or ScreenPRO-II Processor.

Note

If asterisks appear around an ID (e.g., * 6 *), the ID has not been detected by the system.

•SP Input — Applies to direct ScreenPRO-II connections — this option selects a specific input connector on the ScreenPRO-II.

•VP Input — Applies to direct Video Processor connections — this option selects a specific M/E input connector on the Video Processor.

•Mixer Layer — Applies to direct connections — this “information only” field displays the mixer layer that corresponds to the specific M/E input connector.

•SP Input is mapped to — Applies to direct ScreenPRO-II connections — this “information only” field shows the current ScreenPRO-II input mapping, if present.

•VP Input is mapped to — Applies to direct Video Processor connections — this “information only” field shows the current Processor input mapping, if present.

•Tally Number — Applies to all connections — this option enables you to assign any of the eight available tallies to any input source. There are no restrictions on tally usage. For example, inputs 8 and 23 could both map to tally 4 if desired.

•Press {ADD PATCH} to confirm any change that you make. As you dial through the choices, the status at the bottom of the menu shows if the current choice is already in use.

•Press {DELETE PATCH} to delete all input patch registers for the selected Controller input. When pressed:

~The Connection Type setting changes to “UNDEFINED”

~The Router Input line is cleared.

This procedure is a good starting point if you are uncertain about specific patches.

In Chapter 6, refer to the “Output Format Setup” section on page 285 for important information about the system’s default Input Patch Table.

Encore Presentation System • User’s Guide • Rev 04 189