Barco 26-0313000-00 manual Fåéìí=m~íÅÜáåÖ, Encore Presentation System User’s Guide Rev 275

6. System Setup

Input Patching

fåéìí=m~íÅÜáåÖ

	Encore system setup: Step 9
9	S Prerequisites — Ensure that you are familiar with the Input Source Patch
	Menu. In Chapter 5, refer to the “Input Source Patch Menu” section on

page 188.

This procedure enables you to associate (patch) specific router inputs to specific source buttons on the Controller, and also assign tally connections. This procedure is also used for assigning “direct” connections (from PCs or video sources) to source buttons.

•On the Controller SC, up to 24 inputs can be assigned.

•On the Controller LC, up to 64 inputs can be assigned.

Important

You may not need to change the input patches if you elect to use those in the default Input Patch Table.

Encore creates a unique “Input Patch Table” for each default router. After a factory reset, the Input Patch Table defaults to the following settings:

Table 6-2.Default input patch table after factory reset

Router	Router	Router	Router	Map to	Encore
Number	Name	Type	Sources:	Encore Sources:	Tally
			Controller LC
1	MatrixPRO1	Analog	1 - 16	1 - 16	1 - 8 defined only
2	MatrixPRO2	SDI	17 - 32	17 - 32	Undefined
3	MatrixPRO3	DVI	33 - 48	33 - 48	Undefined
			Controller SC
1	MatrixPRO1	Analog	1 - 16	1 - 16	1 - 8 defined only
2	MatrixPRO2	SDI	17 - 24	17 - 24	Undefined
3	MatrixPRO3	DVI	Undefined	N/A	Undefined

You may elect to use the default patches as shown above, or you can create custom patches as required for specific input configurations.

Tip

The same router input can be patched to one (or more) source numbers. For example, if you want to use a DVD player in both 16:9 and 4:3 formats, patch the DVD to inputs 10 and 42 (the shifted source 10). Using the input setup procedure, set up each input for the desired aspect ratio.

Encore Presentation System • User’s Guide • Rev 04 275