7. Operations

Working with Transitions

tçêâáåÖ=ïáíÜ=qê~åëáíáçåë

Cut

This section provides instructions for performing a variety of transitions. The following topics are discussed:

Cut

Mix

Wipe

Manual Transitions

`ìí

Cuts can be performed on both single screen and widescreen destinations.

„Use the following steps to perform a Cut:

1.Set up the desired “look” in Preview.

2.In the Transition Section, press CUT to instantly cut the setup to Program. Cuts can also be performed directly on Program in the following three modes:

Modify Layers on Program is enabled. Refer to the "Modifying Layers On Program" section on page 328 for details.

Live Switch Program/Preview Mode is enabled. Refer to the "Using Live Switch Program/Preview Mode" section on page 340 for details.

Live Switch Source Mode is enabled. Refer to the "Using Live Switch Program/Preview Mode" section on page 340 for details.

Auto

Trans

jáñ

A Mix (or Dissolve) can be performed on both single screen and widescreen destinations.

„Use the following steps to perform a Mix:

1.Set up the desired “look” in Preview.

2.Preset the mode and transition rate:

a.In the System Keypad, press EFFECTS to display the Effects Menu.

b.Adjust the Transition Rate field, in 0.1 second increments.

c.In the Transition Type field, select Mix.

3.In the Transition Section, press AUTO TRANS to dissolve the setup to Program.

Encore Presentation System • User’s Guide • Rev 04

 

343

 

Page 343
Image 343
Barco 26-0313000-00 manual TçêâáåÖ=ïáíÜ=qê~åëáíáçåë, `ìí, Jáñ, System Keypad, press Effects to display the Effects Menu