3. Hardware Installation

Program and Source Link Connections

`çååÉÅíáåÖ=mêçÖê~ã=~åÇ=pçìêÅÉ=iáåâë

This section provides instructions for connecting Program Link and Source Link connections (DVI-I) in a variety of Encore configurations.

Important

Secure all cable connections tightly to ensure reliable operation. This is important especially for the Program and Source links — as box-to-box synchronization is relayed in these cables for wide screen setups.

iÉÑí=gìëíáÑáÉÇ=`çåÑáÖìê~íáçå

Left justification means that the first pixels of the projected image begin immediately at the left, and that unused source material is removed from the far right of the image. A two- projector sample is illustrated below.

Projector 1

Image

Projector 2

Image

båÅçêÉ

Image

Unused

Overlap

Source

Region

Material

Figure 3-13.Left Justification

Please note:

Left justified systems are connected in daisy-chain fashion.

Up to 32 Encore processors are supported (both VP and VPx).

A VP must be used as processor 1 (master). Thereafter, either a VP or VPx can be used.

„Use the following steps to connect Program and Source Links for left justification:

1.Program Link Connections (DVI-I)

Connect the Program Link Out connector on processor 1 to the Program Link In connector on processor 2, as illustrated below.

Processor 1

(VP only)

Program

 

Program

 

Link In

 

Link Out

 

 

 

 

 

Processor 2

(VP or VPx)

Program

 

Program

 

Link In

 

Link Out

 

 

 

 

 

Processor [n]

(VP or VPx)

Program

 

Program

Link In

 

Link Out

 

 

 

Figure 3-14.Program Link Connections

2.Repeat the procedure for all remaining processors in your configuration.

102

 

Encore Presentation System • User’s Guide • Rev 04

 

Page 102
Image 102
Barco 26-0313000-00 `çååÉÅíáåÖ=mêçÖê~ã=~åÇ=pçìêÅÉ=iáåâë, IÉÑí=gìëíáÑáÉÇ=`çåÑáÖìê~íáçå, Program Link Connections DVI-I