6. System Setup

Router Setup

oçìíÉê=pÉíìé

Encore system setup: Step 7

7

S Prerequisites — Ensure that you are familiar with the following menus:

~ Router Specification Menu. In Chapter 5, refer to the “Router

 

Specification Menu” section on page 190.

 

~ Comm Setup Menu. In Chapter 5, refer to the “Comm Setup Menus

 

section on page 191.

 

~ Output Patch Menu. In Chapter 5, refer to the “Output Patch Menu

 

section on page 194.

„ Use the following steps to set up your system’s routers:

1.

Ensure that your router(s) are properly connected to the Encore system. In

 

Chapter 3, refer to the “Installation” section on page 64 for details.

2.

For Ethernet controlled routers, ensure that your router’s protocol is supported.

 

The list of supported manufacturers currently includes the Folsom MatrixPro

 

series, and routers from Sierra, Extron, Leitch, Isis, DVILink and DPI.

3.

For Ethernet controlled routers, ensure that you know each router’s IP address. If

 

required, preset the IP addresses at the routers themselves. Refer to each

 

router’s User’s Guide for instructions.

 

Note that MatrixPRO routers default to the following IP addresses:

 

~ MatrixPRO Analog Router: 192.168.0.241

 

~ MatrixPRO SDI Router: 192.168.0.242

 

~ MatrixPRO DVI Router: 192.168.0.243

4.

In the System Keypad, press SYSTEM to display the System Menu.

5.

Press {ROUTER SETUP} to display the Router Specification Menu.

6.

On the Number line, select the number that you wish to assign to this router.

Note

This is an arbitrary number used for associating the router with a configuration file. Encore provides an available “pool” of 8 devices from which you can assign routers and D/As.

7.On the Manufacturer line, select the router manufacturer.

8.On the Router Type line, select the type of router being used.

9.On the Number of Inputs line, select the router’s input count.

10.On the Number of Outputs line, select the routers’ output count.

11.On the Communication Type line, select the type of communication that you are using to connect to the router: RS-232, Ethernet or Lantronix.

12.Press {ADD NEW} to save the router’s specification.

13.Press {COMM SETUP} to display the appropriate communications setup menu for the selected device.

14.For Ethernet controlled routers, verify that the IP Address field matches the router’s IP address. If not, use the ADJ knob in conjunction with the {NEXT IP QUAD} button to change the address as required.

270

 

Encore Presentation System • User’s Guide • Rev 04

 

Page 270
Image 270
Barco 26-0313000-00 manual OçìíÉê=pÉíìé, Press Router Setup to display the Router Specification Menu