7. Operations

Working with Transitions

Auto

Trans

táéÉ

All types of wipes can be performed on single screen destinations. On widescreen destinations, you can only perform a Wipe Up or a Wipe Down.

„Use the following steps to perform a Wipe:

1.Set up the desired “look” in Preview.

2.Preset the desired transition rate, wipe effect and wipe edge:

a.In the System Keypad, press EFFECTS to display the Effects Menu.

b.Adjust the Transition Rate field, in 0.1 second increments.

c.In the Transition Type field, select the desired Wipe pattern.

d.In the Transition Edge Width field, select the desired wipe edge.

3.In the Transition Section, press AUTO TRANS to wipe the setup to Program.

j~åì~ä=qê~åëáíáçåë

Cuts and wipes can be performed manually with the T-Bar.

„Use the following steps to perform a manual transition:

1.Set up the desired “look” in Preview.

2.Using the Effects Menu, select a Wipe or Mix in the normal way.

3.In the Transition Section, move the T-Barto manually dissolve (or wipe) the images from Preview to Program.

344

 

Encore Presentation System • User’s Guide • Rev 04

 

Page 344
Image 344
Barco 26-0313000-00 manual TáéÉ, ~åì~ä=qê~åëáíáçåë