Barco 26-0313000-00 manual BñíÉêå~ä=pÉêá~ä=oçìíÉê=`çåÑáÖìê~íáçå

aK==tçêâáåÖ=táíÜ=aÉëíáå~íáçåë

ScreenPRO-II Configurations

bñíÉêå~ä=pÉêá~ä=oçìíÉê=`çåÑáÖìê~íáçå

The diagram below shows a configuration that uses two ScreenPRO-II units with external source routing. Each ScreenPRO-II is set up as a unique destination.

In this configuration, two external serial (RS-232) routers are used — one for analog connections and one for SDI source connections to each ScreenPRO-II. Because two serial connections are required, a Lantronix UDS200 is used.

	Router
MatrixPRO SDI Router	Outputs

SDI

Inputs

RS-232

MatrixPRO Analog Router

Analog

Inputs

RS-232

LantronixEthernet

UDS200

InputsScreenPRO-II

Encore Controller (SC or LC)

Side Screen 1

Side Screen 2

Ethernet Switch

Figure D-2.ScreenPRO-II units using external serial controlled routers

For an “external routing” configuration with serial controlled routers, please note the following points regarding destination setup and source connections:

•On the Destination Setup Menu:

~Select Single Screen SP as the “Type.”

~Set the “Routing Mode” to External.

~In Chapter 6, refer to the “ScreenPRO-II Destination Setup” section on page 279 for instructions.

•Connect analog and digital sources to each router in the normal manner.

•For each router, connect two outputs to each ScreenPRO-II.

•On the Router Specification Menu, select the correct router and manufacturer, and set the “Communication Type” to LANTRONIX. In Chapter 6, refer to the “Router Setup” section on page 270 for instructions.

•Router outputs are mapped using the Output Patch Menu. This menu defines which router output connects to which ScreenPRO-II input. In Chapter 6, refer to the “Router Setup” section on page 270 for instructions.

•Router inputs are mapped using the Input Patch Menu. In Chapter 6, refer to the “Output Format Setup” section on page 285 for instructions.

Encore Presentation System • User’s Guide • Rev 04 395