Barco 26-0313000-00 manual TçêâáåÖ=ïáíÜ=aÉëíáå~íáçåë, Åíáî~íáåÖ=~åÇ=aÉ~Åíáî~íáåÖ=aÉëíáå~íáçåë

7. Operations

Working with Destinations

tçêâáåÖ=ïáíÜ=aÉëíáå~íáçåë

Destinations can be configured as single screens (projectors), multiple screens (in wide screen applications), single or wide screen "stack" configurations, ScreenPRO-II systems, auxiliary router outputs, ImagePRO systems and PresentationPRO-II systems.

During system setup, multiple destinations can be configured:

•On the Controller SC, 6 destinations are available.

•On the Controller LC, 32 destinations are available.

In Chapter 6, refer to the “Destination Setup" section on page 277 and the “Projector Setup" section on page 288 for complete destination setup instructions.

The following topics are discussed in this section:

•Activating and Deactivating Destinations

•Clearing Destinations

•Routing Sources to Aux Destinations

1

^Åíáî~íáåÖ=~åÇ=aÉ~Åíáî~íáåÖ=aÉëíáå~íáçåë

„Use the following steps to activate and deactivate destinations:

1.Activate — press the desired button on the Destination Bus to route signals to that destination (e.g., single or multiple projectors, Aux, ScreenPRO-II, etc.). The button lights when activated. Any combination of destination buttons can be enabled sequentially — the buttons are not mutually exclusive.

2.Deactivate — press Clear + the desired button on the Destination Bus to remove the selected destination from the output routing. Any combination of destination buttons can be cleared sequentially.

Note

“Groups” can also be used to activate and deactivate single or multiple destinations with one-button ease. Refer to the “Working with Groups" section on page 312 for details.

3.Isolate One — If multiple destinations are active, press and hold one destination button to momentarily isolate that destination for modification. Release to return to the “group” selection.

Clear

`äÉ~êáåÖ=aÉëíáå~íáçåë

„Use the following steps to clear destinations:

1.To clear a single destination, press Clear + the desired button on the Destination Bus to remove it from the output routing.

2.(Controller LC only) To clear all destinations, press Clear + All.

Encore Presentation System • User’s Guide • Rev 04 315