Barco 26-0313000-00 manual Aph=pÉíìé, Fåéìí=pÉíìé=kçíÉë

6. System Setup

DSK Setup

fåéìí=pÉíìé=kçíÉë

You do not have to repeat the input setup procedure for other destinations if either of the following criteria are met:

•Your other destinations use sources that are patched to the same router.

•Your other destinations are configured using the “ALL SP” function on the Input Source Patch Menu.

In this case, all other system destinations will automatically receive input configuration files via the system’s “copy down” functionality.

You do have to repeat the input setup procedure if either of the following criteria are met:

•Your other destinations use a different router.

•Your other destinations use unique input patching.

aph=pÉíìé

	Encore system setup: Step 18
18	S Prerequisites — Ensure that you are familiar with the following menus:
	~ DSK Adjustment Menu. In Chapter 5, refer to the “DSK Adjustment

Menu” section on page 254.

~ DSK Input Setup Menu. In Chapter 5, refer to the “DSK Input Setup Menu” section on page 257.

In this procedure, you will set up the Controller’s DSK source. An Encore DSK can be configured as a DVI input, an analog input, a frame grab or “none.”

Please note the following important points:

•For ScreenPRO-II destinations, remember that BG B and the DSK are mutually exclusive. This occurs because the BG/DSK Input B is shared between the DSK and BG B on all individual ScreenPRO-II units.

•For single or wide screen Encore systems using single M/E Video Processors, there are only two DVI input connectors available (1A and 1B). In this configuration, you can not set up both backgrounds and the DSK — you can only configure two of the three (e.g., both backgrounds, or one background plus DSK).

•For stack configurations, remember that the background sources connect to the “bottom” stack Processor, while DSK sources connect to the “top” stack.

„Use the following steps to set up your DSK source:

1.On the Controller, press DSK to display the DSK Adjustment Menu.

2.Press {INPUT SETUP} to display the DSK Input Setup Menu.

3.On the Destination line, select the destination on which you want to set up the downstream key.

~If multiple destinations are active, select the desired destination.

~If a single destination is active, selections cannot be made.

4.On the ID line, select the IDs of the Processor(s) for which you want set up the downstream key.

~For single screen destinations, ID selections cannot be made.

296 Encore Presentation System • User’s Guide • Rev 04