aK==tçêâáåÖ=táíÜ=aÉëíáå~íáçåë

PresentationPRO-II Aux Configuration

mêÉëÉåí~íáçåmolJff=^ìñ=`çåÑáÖìê~íáçå

SDI Inputs

Analog Inputs

PresentationPRO-II units can be connected to the Encore Controller via Ethernet for use as Aux destinations. In this manner, AUX outputs from up to two routers are connected to the PresentationPRO-II — so that any available source used in the Encore system can be displayed on a given monitor.

The diagram below shows a PresentationPRO-II Aux configuration that uses one analog router and one SDI router.

 

Router

Monitor

MatrixPRO SDI Router

Outputs

 

 

InputsPresentationPRO-II

MatrixPRO Analog Router

Encore Controller (SC or LC)

Ethernet Switch

Figure D-5.PresentationPRO-II Aux connections

„Use the following steps to properly prepare a PresentationPRO-II system for setup as an Aux destination:

1.Ensure that you are running software Version 1.12 (or above) on the PresentationPRO-II. If not, download software in the normal manner from the FTP site (ftp.folsom.com) or the web site (www.barco.com).

2.On each router (1 x Analog, 1 x SDI), ensure that an unused router output is physically connected to a PresentationPRO-II input. Make a note of these connection patches, as they will need to be entered during the setup procedure.

3.Before you connect the PresentationPRO-II to the Encore Controller, set up the PresentationPRO-II’s output resolution at the unit itself. Ensure that you match the resolution of the monitor connected to the system.

4.On PresentationPRO-II’s Effects Menu, set up the transition parameters that the unit will use when AUTO TRANS is pushed on the Encore Controller.

5.(Optional) If a BG (background) or DSK (Downstream Key) needs to be on Program at all times, set up this input on the PresentationPRO-II, and transition it to Program — prior to placing the PresentationPRO-II into remote control mode.

6.Complete the setup procedure by setting up the Aux destination(s) on the Encore Controller. In Chapter 6, refer to the “AUX Destination Setup” section on page 281 for instructions.

398

 

Encore Presentation System • User’s Guide • Rev 04

 

Page 398
Image 398
Barco 26-0313000-00 manual MêÉëÉåí~íáçåmolJff=ìñ=`çåÑáÖìê~íáçå, Figure D-5.PresentationPRO-II Aux connections