Barco 26-0313000-00 manual PóëíÉã=pÉíìé=pÉèìÉåÅÉ, Encore Presentation System User’s Guide Rev 261

6. System Setup

System Setup Sequence

póëíÉã=pÉíìé=pÉèìÉåÅÉ

This section provides a top level view of the entire Encore setup procedure, plus links to each individual sequence.

Important

„Preliminary steps:

For the optimum Encore setup, it is recommended that you follow all procedures in the order outlined below.

1.“ID Setup and Remote Enable,” page 262.

2.“Peripheral Power Up and Status Check,” page 264.

3.“Return to Factory Default,” page 266.

„Next, set up all menus under the MISC heading:

4.“Touch Screen Calibration,” page 267.

5.“Programming EDID,” page 268.

6.“Restore from Flash Memory Card,” page 269.

„Next, set up all menus under the System heading:

7.“Router Setup,” page 270. Router setup

8.“D/A Setup,” page 274. D/A setup

9.“Input Patching,” page 275. Input Patching

10.“Destination Setup,” page 277. Destination Setup

11.“AUX Destination Setup,” page 281. Aux Destination Setup

„Next, set up all menus under the Output heading:

12.“Output Format Setup,” page 285.

13.“Sync Setup,” page 286.

14.“Genlock Setup,” page 287.

15.“Projector Setup,” page 288.

„Set up all background inputs, all primary sources and the DSK:

16.“Background Setup,” page 291.

17.“Input Setup,” page 293.

18.“DSK Setup,” page 296.

„To complete your setup:

19.“Saving the Setup,” page 299.

20.“Back up System,” page 300.

All of the above procedures are covered in the following sections.

Encore Presentation System • User’s Guide • Rev 04 261