Barco 26-0313000-00 manual Output Connections

3. Hardware Installation

Installation

d.Ensure that all sources are properly connected to your router(s).

e.Connect all selected router outputs to the desired M/E inputs.

9.ScreenPRO-II Connections — if your system includes one (or more) destination ScreenPRO-II units, you can configure the unit for internal or external routing:

a.When External routers are used, connect two outputs from an Analog router to any two HD-15 inputs on the ScreenPRO-II. An SDI router can also be connected to BNC inputs 1 and 2. During setup, these specific patches will be defined using the Output Patch Menu.

b.When Internal routing is used, connect Analog sources to inputs 1 - 8 on the HD-15 connectors, and SDI sources to BNC inputs 1 and 2. During setup, these patches will be defined using the Input Patch Menu.

In Chapter 6, refer to the “ScreenPRO-II Destination Setup” section on page 279 for more information.

10.Output Connections —

a.Connect the VP’s analog or digital Preview Output to the input of your Preview Monitor.

b.Connect the VP’s analog or digital Program 2 Output to the input of your Program Monitor.

c.Connect the analog or digital Program 1 Output to the projector input.

d.Connect the Program Out HD/SDI connector to an SDI or HDTV monitor, or to the proper video distribution equipment.

Note

This output only works if the selected output resolution is a valid SDI or HD/SDI format.

11.Aux Destinations — you can configure three types of Aux destinations: Aux (monitors), ImagePRO Aux and PresentationPRO-II Aux. Refer to Appendix D, “Working With Destinations” on page 393 for interconnection details.

12.Power Connection — connect AC power cords to the AC Power Connectors on the rear of the VP and Controller, and then to AC outlets. Connect AC Power cords (or AC adapters) to all peripheral equipment. Please note:

~Connect each unit only to a properly rated supply circuit.

~Reliable grounding of rack-mounted equipment should be maintained.

13.Tally Connection — the Controller provides one 25-pin D connector for issuing “relay closure” commands to external devices. Eight circuits are provided. In Appendix A, refer to the “Tally Connector” section on page 374 for details.

14.System ID — Using the Unit ID Selector, set the ID of the VP to 1.

Note

Using the Miscellaneous Menu, you can redefine IDs using numbers 17 - 32. In Chapter 5, refer to the “Miscellaneous Menu” section on page 196 for details.

15.If your system includes remote destinations such as ScreenPRO-IIunits, refer to Appendix D, “Working With Destinations” on page 393 for connection details.

16.Power On — all power on instructions are covered in Chapter 6.

Please continue with Chapter 4, “Controller Orientation” on page 107.

Encore Presentation System • User’s Guide • Rev 04 67