Barco 26-0313000-00 Following rules apply to VPx, Encore Presentation System User’s Guide Rev 183

Note

5. Menu Orientation

System Menu

When an Aux, ImagePRO Aux or PrePRO-II Aux destination is selected, the {AUX SETUP} button appears, which enables you to set the parameters of the Aux destination. Refer to the “Aux Setup Menu” section on page 184 for details.

•VP (SP) to Add — lists all available VP, VPx or ScreenPRO-IIs that can be assigned to the destination. If a Processor is currently assigned to another destination, it will not appear in the list. Processors are identified by ID.

Note

The following rules apply to VPx:

•A VP must be used as the “master” processor. Thereafter, either a VP or a VPx can be used.

•A VPx can only be used in a single processor configuration in the widescreen “preview” mode.

•VP (SP) to Remove — lists all assigned VP, VPx or ScreenPRO-IIs that can be removed from the destination. Processors are identified by ID.

•Dimensions — When two or more VP or VPx units are added to a destination, the Dimensions field appears. This field enables you to select any combination of the available VP or VPx units, and lay them out in a horizontal only, vertical only, or horizontal plus vertical array. The selected dimension is expressed in a W (width) x H (height) formula, e.g., 2W x 2H.

Note

If the widescreen destination includes any vertical blending element, it affects the Wide Screen Settings Menu. Refer to the “Wide Screen Settings Menu” on page 167 for details

•Analog Routing Mode — if Single Screen SP is selected as the “Type,” this field enables you to set the routing mode for ScreenPRO-II’s analog inputs.

~Select Internal to use ScreenPRO-II’s internal 8x2 matrix to select analog sources. Use the “Input Source Patch Menu” to patch inputs.

~Select External to use an external analog router that is connected to ScreenPRO-II to select your analog sources. Use the “Output Patch Menu” to patch your inputs.

•SDI Routing Mode — if Single Screen SP is selected as the “Type,” this field enables you to set the routing mode for ScreenPRO-II’s SDI inputs.

~Select Internal to use ScreenPRO-II’s internal 2x2 matrix to select SDI sources. Use the “Input Source Patch Menu” to patch inputs.

~Select External to use an external SDI router that is connected to ScreenPRO-II to select SDI sources. Use the “Output Patch Menu” to patch your inputs.

•At the bottom of the menu, the Status section dynamically lists the Processor IDs assigned to the current destination.

•Press {ADD} to add the selected VP, VPx or ScreenPRO-II (on the VP [SP] to Add line) to the current destination configuration.

Encore Presentation System • User’s Guide • Rev 04 183