Barco 26-0313000-00 manual PçìêÅÉ=pÉäÉÅíáçå=ìë, Source Selection Bus, Controller SC

4. Controller Orientation

Controller Sections

pçìêÅÉ=pÉäÉÅíáçå=_ìë

The figures below illustrate the Source Selection Bus on each Controller.

SOURCE SELECTION

Program

7	8	9	10	11	12	Shift
19	20	21	22	23	24

Program

1	2	3	4	5	6
13	14	15	16	17	18

Figure 4-13.Source Selection Bus, Controller SC

SOURCE SELECTION

Program

17	18	19	20	30	31	32	Shift
49	50	51	52	62	63	64

Program

1	2	3	13	14	15	16
33	34	35	45	46	47	48

Figure 4-14.Source Selection Bus, Controller LC

Please note the following important points:

•Each numbered button represents two sources — one shifted and one un-shifted.

•The Controller SC includes buttons for 24 sources.

~Sources 1 - 12 are accessed directly.

~Sources 13 - 24 are accessed by pressing Shift + source.

•The Controller LC has buttons for 64 sources.

~Sources 1 - 32 are accessed directly.

~Sources 33 - 64 are accessed by pressing Shift + source.

•Each source button represents an input that you can assign to a PIP or Key, or route to a specified destination. Each input is either a “direct” connection to the Processor or an assigned router input.

In Chapter 6, refer to the “Input Setup” section on page 293 for details on source setup procedures.

126 Encore Presentation System • User’s Guide • Rev 04