6. System Setup

Projector Setup

13.Scroll to the Marker Mode line and enable (or disable) the system’s wide screen markers. If enabled, you can see the boundaries of active data on Preview.

Note

As required, you can change the Marker Mode during operations without affecting other wide screen settings.

14.Scroll to the Overlap Width line and enter the desired overlap between projectors. The value is in pixels.

15.Scroll to the Data Doubling line and disable data doubling.

16.Scroll to the Justification line and set the desired wide screen justification, either Center or Left.

17.In the Feathering section, scroll to the Mode line and disable edge feathering.

18.Scroll to the Gamma line and set the gamma for the feathered regions. The default value is 2.2.

19.At each projector, perform the following adjustments to ensure that the output data is properly displayed:

~Adjust the images for a minimum amount of noise.

~Adjust the pixel clocks for proper image position, such that the entire Raster Box is visible.

20.Press {BACK} to return to the Output Menu.

21.Press {TEST PATTERN} to display the Test Pattern Menu.

22.On the Type line, select one of the many Gray Scale test patterns, as desired.

23.At each projector, adjust brightness, contrast and color balance.

Important

Refer to your projector’s technical manual for information on all projector setup and adjustment procedures.

24.Once each projector is properly set, scroll to the Alignment Test Pattern line and enable the function. This special test pattern allows you to perform projector lens shift and registration adjustments.

a.At each projector, perform lens shift and registration adjustments.

b.If required, adjust the horizontal and vertical “totals” to match those entered on the Wide Screen Settings Menu.

Note

Refer to your projector’s technical manual for information on all lens shift and registration procedures.

c.When adjustments are complete, turn off the Alignment Test Pattern.

25.Re-enable edge feathering and data doubling (if required for your configuration).

26.Press {BACK} to return to the Output Menu.

27.Repeat from step 3 for additional wide screen destination projector setups.

28.When all projectors for wide screen destinations have been set up, press SAVE in the System Keypad to save the new configuration in memory.

290

 

Encore Presentation System • User’s Guide • Rev 04

 

Page 290
Image 290
Barco 26-0313000-00 manual 290