aK==tçêâáåÖ=táíÜ=aÉëíáå~íáçåë

ImagePRO Aux Configuration

fã~ÖÉmol=^ìñ=`çåÑáÖìê~íáçå

SDI Inputs

DVI Inputs

Analog Inputs

ImagePRO units can be connected to the Encore Controller via Ethernet for use as Aux destinations. In this manner, AUX outputs from up to three routers are connected to the ImagePRO — so that any available source used in the Encore system can be displayed on a given monitor.

The diagram below shows a ImagePRO Aux configuration that uses one analog router, one DVI router and one SDI router.

 

Router

Monitor

MatrixPRO SDI Router

Outputs

 

 

Inputs

ImagePRO

MatrixPRO DVI Router

 

 

Encore Controller (SC or LC)

MatrixPRO Analog Router

Ethernet Switch

Figure D-6.ImagePRO Aux connections

„Use the following steps to properly prepare an ImagePRO system for setup as an Aux destination:

1.Ensure that you are running software Version 2.30 (or above) on the ImagePRO. If not, download software in the normal manner from the FTP site (ftp.folsom.com) or the web site (www.barco.com).

2.On each router (1 x Analog, 1 x SDI, 1 x DVI), ensure that an unused router output is physically connected to an ImagePRO input. Make a note of these connection patches, as they will need to be entered during the setup procedure.

3.Before you connect the ImagePRO to the Encore Controller, set up the ImagePRO’s output resolution at the unit itself. Ensure that you match the resolution of the monitor connected to the system.

4.On ImagePRO’s Effects Menu, set up the transition parameters that the unit will use when AUTO TRANS is pushed on the Encore Controller.

5.Complete the setup procedure by setting up the Aux destination(s) on the Encore Controller. In Chapter 6, refer to the “AUX Destination Setup” section on page 281 for instructions.

Encore Presentation System • User’s Guide • Rev 04

 

399

 

Page 399
Image 399
Barco 26-0313000-00 manual Fã~ÖÉmol=ìñ=`çåÑáÖìê~íáçå, Encore Presentation System User’s Guide Rev 399