Barco 26-0313000-00 manual Tdb

		3. Hardware Installation
		Installation
Table 3-4.Equipment List, Wide Screen Encore Configuration (Continued)
Qty.	Item	Note
1	Controller	Model LC or SC
3	Video Projectors	Customer supplied.
6	DVI or Analog Monitors	Program and Preview (customer supplied).
1	Ethernet Switch	Customer supplied
4	Ethernet cables	Customer supplied. Additional cables required for routers.
TBD	Program Link Cables (DVI-I)	Use 1 for double wide screen application, left justification
		Use 2 for triple wide screen application, left justification
		Use 2 for double wide screen application, center justification
		Use 3 for triple wide screen application, center justification
TDB	Source Link Cables (DVI-I)	Dependent on the number of M/Es installed in the Processors
TBD	Sources, routers and cables	Analog, Video and/or DVI as required (customer supplied)

„Use the following steps to install a wide screen Encore configuration:

1.Follow the unpacking procedures as listed in the “Unpacking and Inspection” section on page 62.

2.In Appendix A, refer to the “Physical and Electrical Specifications” section on page 367 for electrical and mechanical details.

3.In Chapter 2, refer to the “Video Processor Rear Panel” section on page 45 and the “Controller Rear Panels” section on page 58 for all connector locations.

4.For each VP and VPx, follow the rack mount procedures as outlined in the “Rack- Mount Installation” section on page 62.

5.Ethernet Connections — a totally “local” network connection is recommended:

a.Connect the VP(s), VPx(s) and Controller to the Switch.

b.Connect router(s) to the Switch.

c.As required, connect ScreenPRO-II, PresentationPRO-II and ImagePRO systems to the Switch.

6.Direct Source Connections — if you elect to use direct connections, in place of (or in addition to) router connections:

a.As a prerequisite, complete your “Connection Charts” on page 89.

b.Connect the desired “direct” sources to each M/E’s input connectors on each VP or VPx. In a wide screen system, scaled sources only connect to Processor 1. “Links” carry the signals to the other VP or VPx units.

c.Unscaled Backgrounds must originate from computers with multi-head graphics cards, and connect to the same input on each VP or VPx.

S To connect an unscaled background source in a triple processor system (each VP or VPx with three M/Es):

•Connect the computer’s “head 1” to processor 1, input 3A

•Connect the computer’s “head 2” to processor 2, input 3A

Encore Presentation System • User’s Guide • Rev 04 73