Barco 26-0313000-00 ~ÅâÖêçìåÇ=pÉíìé, Press Back to return to the Background Input Setup Menu

6. System Setup

Background Setup

_~ÅâÖêçìåÇ=pÉíìé

	Encore system setup: Step 16
16	S Prerequisites — Ensure that you are familiar with the following menus:
	~ Background Input Setup Menu. In Chapter 5, refer to the

“Background Input Setup Menu” section on page 237.

~ BG Matte Menu. In Chapter 5, refer to the “BG Matte Menu” section on page 241.

In this procedure, you will set up the Controller’s two “background” sources (for the BG A and BG B buttons). An Encore background can be configured as a DVI input, an analog input, a matte color or a frame grab.

Please note the following important points:

•For ScreenPRO-II destinations, remember that BG B and the DSK are mutually exclusive. This occurs because the BG/DSK Input B is shared between the DSK and BG B on all individual ScreenPRO-II units.

•For single or wide screen Encore systems using single M/E Video Processors, there are only two DVI input connectors available (1A and 1B). In this configuration, you can not set up both backgrounds and the DSK — you can only configure two of the three (e.g., both backgrounds, or one background plus DSK).

•For stack configurations, remember that the background sources connect to the “bottom” stack Processor, while DSK sources connect to the “top” stack.

„Use the following steps to set up your background sources:

1.On the Destination Bus, select the destination whose background sources you want to configure.

2.On the Controller, press BG A to display the Background Input Setup Menu.

3.To configure a matte background:

a.Scroll to the Type line and select Matte.

b.Press {MATTE} to display the BG Matte Menu.

c.Adjust the matte color as desired.

d.Press {BACK} to return to the Background Input Setup Menu.

e.Press {SAVE}.

4.To configure a DVI background:

a.Ensure that your DVI source (e.g., a PC) is properly connected to the Video Processor or ScreenPRO-II chassis, and that the PC is turned on.

b.Ensure that EDID is properly set. If not, refer to the “Programming EDID” section on page 268 for details.

c.Scroll to the Type line and select DVI.

d.Set the DVI source’s format:

•Press {FORCE ACQUIRE}, or ...

•To manually set the source’s resolution, select the desired format on the Format line, then press {APPLY FORMAT}.

e.(Optional) Adjust H Offset and V Offset as required.

Encore Presentation System • User’s Guide • Rev 04 291