Barco 26-0313000-00 manual PóåÅ=pÉíìé, Refer to the Settings Menu section on

6. System Setup

Sync Setup

póåÅ=pÉíìé

	Encore system setup: Step 13
13	S Prerequisites — Ensure that you are familiar with the Settings Menu. In
	Chapter 5, refer to the “Settings Menu” section on page 165.

In this procedure, you will set up sync parameters for the monitors and projectors connected to the system — for the destination selected on the Output Menu.

Note

It is recommended that you leave the sync parameters at their default (factory reset) values. However, should you need to adjust individual settings for a particular monitor and projector configuration, use the following procedure.

„Use the following steps to set up sync parameters:

1.In the System Keypad, press OUTPUT to display the Output Menu.

2.On the Destination Bus, select the destination that you want to configure.

3.Press {SETTINGS} to display the Settings Menu.

4.On the Output Monitor line, select the device(s) that are affected by the sync settings — All, Preview, Program 1 or Program 2.

5.On the Sync Out line, set the desired sync value — +H+V, -H-V, +H-V, -H+Vor CSync.

6.On the SOG line, select a specific “sync on green” signal — Off, Standard or Tri- Level (for certain HD devices).

7.On the Gamma line, set the output gamma for the selected destination.

Important

It is recommended that you leave Gamma at the unity setting (1.0). Change the value only if you need to compensate for a gamma problem in your projector or monitor.

8.On the Raster Box Size line, set the size of the raster box that appears around PIPs and Keys. The range is 0 to 8 pixels. Note that the 0 setting effectively turns the raster box off.

Note

As required, you can change the Raster Box value during operations without affecting sync settings.

9.Press {BACK} to return to the Output Menu.

10.Repeat from step 2 to set sync parameters for additional destinations.

11.In the System Keypad, press SAVE to save the new configuration in memory.

286 Encore Presentation System • User’s Guide • Rev 04