Barco 26-0313000-00 manual 294

6. System Setup

Input Setup

This action isolates the source within the PIP, displays a gray background, turns off borders and shadows, and displays the Input Menu.

Note

Source Preview is not available with “stack” configurations. In this situation, first turn off borders and shadows, then press INPUT in the System Keypad.

4.On the Source Selection Bus, select the source that you want to set up.

5.Press {FORCE ACQUIRE} to perform the optimum image setup.

6.Perform additional setups on the Input Menu — if required:

a.(Optional) Scroll to the Input Connector line and select the physical connector to which the input is connected, either HD-15, DVI or BNC. If you perform this step, press {FORCE ACQUIRE}.

b.If you need to manually set the resolution, scroll to the Format line and select the desired format. Press {APPLY FORMAT} to accept.

c.Scroll to the Input Type line and set the type of input. Remember that the choices change depending on the selected Format, and in some cases, this function is not available.

d.Scroll to the Color Space line, and set the input’s color space, either SMPTE or RGB. In some cases, this function is not available.

e.Scroll to the Sampling Mode line and set the sampling mode.

f.Scroll to the Contrast line and set the input’s contrast.

g.Scroll to the Brightness line and set the input’s brightness.

h.Scroll to the Gamma line and set the input gamma.

i.Scroll to the Input Sync Type line and set the source’s sync type.

j.Scroll to the Pulldown Compensation line and enable (or disable) the mode. Remember that this function only applies to standard video (component, s-video, composite) inputs.

k.Scroll to the Sync Slice <mv> line and adjust as required.

l.Scroll to the Sharpness line and set the input’s sharpness.

m.Press {SAVE} to save the input configuration.

7.Perform additional setups on the Aspect Ratio Menu — if required:

a.Press {AR} to display the Aspect Ration Menu.

b.Adjust the Mode and Ratio as required.

c.Press {SAVE} to save the input configuration.

d.Press {BACK} to return to the Input Menu.

8.Perform additional setups on the Sizing Menu — if required:

a.Press {SIZING} to display the Sizing Menu.

b.If 1:1 Sampling was selected:

•Scroll to the Clock Phase line and adjust for the cleanest, brightest and sharpest image.

•Scroll to the H Total line and set the total pixel count per line.

•Scroll to the H Active line and set the width of the active area.

294 Encore Presentation System • User’s Guide • Rev 04