138 Encore Presentation System • User’s Guide • Rev 04
4. Controller Orientation
Controller Sections
Learn — (Controller LC only)
•To learn (program) a group button, activate the desired destinations on the
Destination Bus, press and hold Learn, then press the desired Group button.
This same method can be used to add (or remove) destinations from the group —
simply by re-learning the button with a new array of destinations.
•To unlearn (completely clear) a group button so that it no longer lights, clear all
destinations on the Destination Bus (Clear + All), press and hold Learn, then
press the desired Group button. Here, you are essentially programming the
button with “no destinations.”
Learn method — (Controller SC only)
•To learn a group button, press and hold the desired Group button, then press the
desired destination button(s) on the Destination Bus.
•To add a destination to an existing group, first select the group, press and hold the
Group button, then press the desired new destination.
•To remove destinations from a group, first select the group, press and hold the
Group button, then press the lit destination button that you want to remove. This
method can also be used to unlearn (completely clear) a group button so that it no
longer lights.
In Chapter 7, refer to the “Working with Groups” section on page 312 for instructions on
all group functions.
Please note the following important points regarding group buttons:
•If you enable a group that fully contains all the destinations from another group,
both group buttons will light.
SGroup 1 contains destinations 1 and 2, Group 2 contains destinations 3 and
4, and Group 3 contains destinations 1, 2, and 4. When you press the
Group 3 button by itself, it lights, and the Group 1 button also lights —
because both Group 1 destinations are fully included in Group 3.