aK==tçêâáåÖ=táíÜ=aÉëíáå~íáçåë

ScreenPRO-II Configurations

bñíÉêå~ä=pÉêá~ä=~åÇ=bíÜÉêåÉí=oçìíÉê=`çåÑáÖìê~íáçå

The diagram below shows a configuration that uses two ScreenPRO-II units with external source routing. Each ScreenPRO-II is set up as a unique destination. One external Ethernet router is used, and one external serial router is used.

InputsScreenPRO-II

 

 

 

 

 

 

 

 

 

 

Router

 

 

 

 

 

 

 

 

 

 

 

MatrixPRO SDI Router

Outputs

 

 

 

 

 

 

 

 

 

 

SDI

Inputs

RS-232

MatrixPRO Analog Router

Analog

Inputs

Encore Controller (SC or LC)

Ext Comm

Side Screen 1

Side Screen 2

Ethernet Switch

Figure D-4.ScreenPRO-II units using external serial and Ethernet routers

For an “external routing” configuration with Ethernet controlled routers, please note the following points regarding destination setup and source connections:

On the Destination Setup Menu:

~Select Single Screen SP as the “Type.”

~Set the “Routing Mode” to External.

~In Chapter 6, refer to the ScreenPRO-II Destination Setup” section on page 279 for instructions.

Connect analog and digital sources to each router in the normal manner.

For each router, connect two outputs to each ScreenPRO-II.

On the Router Specification Menu, select the correct router and manufacturer. In Chapter 6, refer to the “Router Setup” section on page 270 for instructions.

~For the serial router, set the “Communication Type” to RS-232.

~For the Ethernet router, set the “Communication Type” to ETHERNET.

Router outputs are mapped using the Output Patch Menu. This menu defines which router output connects to which ScreenPRO-II input. In Chapter 6, refer to the “Router Setup” section on page 270 for instructions.

Router inputs are mapped using the Input Patch Menu. In Chapter 6, refer to the “Output Format Setup” section on page 285 for instructions.

Encore Presentation System • User’s Guide • Rev 04

 

397

 

Page 397
Image 397
Barco 26-0313000-00 BñíÉêå~ä=pÉêá~ä=~åÇ=bíÜÉêåÉí=oçìíÉê=`çåÑáÖìê~íáçå, Encore Presentation System User’s Guide Rev 397