Barco 26-0313000-00 manual IáîÉ=pïáíÅÜ=ìñ=oçìíáåÖ, MêçÖê~ãLmêÉîáÉï=ìñ=oçìíáåÖ

Source

7. Operations

Working with Destinations

iáîÉ=pïáíÅÜ=^ìñ=oçìíáåÖ

„Use the following steps to switch Aux destinations live.

1.On the Destination Bus, enable the desired Aux destination(s).

2.Press Shift + Source (in the Live Switch Section). The Source button lights to indicate the live mode is enabled, and the Source Selection Bus is now a “live” Aux switcher.

3.On the Source Selection Bus, select the desired source. Encore immediately routes that source to the selected Aux destination(s).

Note In this mode, Program LEDs are disabled.

4.To clear the mode, press Shift + Source. The light turns off, and the Source Selection Bus is returned to its normal functionality.

Program

Preview

mêçÖê~ãLmêÉîáÉï=^ìñ=oçìíáåÖ

„Use the following steps to switch Aux destinations using the Program/Preview method.

1.On the Destination Bus, enable the desired Aux destination(s).

2.Press Shift + Program/Preview (in the Live Switch Section). The Program/ Preview button lights to indicate the mode is enabled.

~On the Source Selection Bus, the bottom row is now the Preview bus, while the top row is now the Program Bus.

~The top Program bus is now mapped with the same inputs as the bottom Preview bus, but note that on both Controllers, only half of your inputs are available:

•On the Controller SC, inputs 1 - 6 and shifted inputs 7 - 12 are available (but they are mapped to the Preview row). Inputs 13 - 24 are not available.

•On the Controller LC, inputs 1 - 16 and shifted inputs 17 - 32 are available (but they are mapped to the Preview row). Inputs 33 - 64 are not available.

3.On the Preview Bus, select (pend) the desired source.

4.Perform the desired transition (e.g., CUT, AUTO TRANS). The Program Bus switches to the new source, and the Preview Bus clears.

5.To clear the mode, press Shift + Program/Preview. The light turns off, and the Source Selection Bus is returned to its normal functionality.

Please note the following points regarding the Program/Preview mode:

•You can not see the selected Preview source prior to transition, because Aux destinations are "single scaler" devices.

•Program LEDs are disabled on the Source Selection Bus only — not in the Layer Control Section.

•You can also "live switch" directly on the Program Bus.

Encore Presentation System • User’s Guide • Rev 04 317