Barco 26-0313000-00 manual PÅêÉÉåmolJff=aÉëíáå~íáçå=pÉíìé

6. System Setup

Destination Setup

pÅêÉÉåmolJff=aÉëíáå~íáçå=pÉíìé

In this procedure, you will set up ScreenPRO-II systems as single screen destinations. Once assigned, the associated button(s) on the Destination Bus will be active.

SPrerequisites — Ensure that you are familiar with the ways in which a ScreenPRO-II system can be physically configured as a destination. In Appendix D, refer to the “ScreenPRO-II Configurations” section on page 393 for details.

„Use the following steps to set up a ScreenPRO-II destination:

1.In the System Keypad, press SYSTEM to access the System Menu.

2.Press {DEST SETUP} to display the Destination Setup Menu.

3.On the Destination line, select the destination that you want to define.

4.(Optional) If desired, press {REMOVE ALL} to remove all previously assigned Video Processors (VPs) from the selected destination.

5.Scroll to the Type line and select Single Screen SP.

6.Scroll to the SP to Add line and select the ScreenPRO-II ID that you wish to add.

7.Press {ADD} to add the highlighted ScreenPRO-II. Once added, the ID appears in the bottom portion of the menu.

8.If required, scroll to the SP to Remove line, select the ID of the ScreenPRO-II that you want to remove from the destination, and press {REMOVE}.

9.Scroll to the Routing Mode line and select Internal or External — depending on the way that you want to configure your source routing. Please note:

~When External routers are used, connect two outputs from an Analog router to any two HD-15 inputs on the ScreenPRO-II. An SDI router can also be connected to BNC inputs 1 and 2. During setup, these specific patches will be defined using the Output Patch Menu.

~When Internal routing is used, connect Analog sources to inputs 1 - 8 on the HD-15 connectors, and SDI sources to BNC inputs 1 and 2. During setup, these patches will be defined using the Input Patch Menu.

10.Repeat from step 3 for each additional ScreenPRO-II destination that you want to set up.

This completes the procedure for defining ScreenPRO-II destinations. The selected buttons on the Destination Bus are now active. Please note:

•When a ScreenPRO II destination uses “external” routing, the OUTPUT PATCH table for the external router allows you to choose which analog input on the ScreenPRO II is being used by the router output. These procedures are covered in the Router Setup section.

•When a ScreenPRO II destination uses internal routing, you can patch individual inputs, or you can define selected source buttons to use the same input for all ScreenPRO IIs. This method is ideal if you are using D/As to connect sources to similar inputs on each ScreenPRO-II. These procedures are covered in the Input Patching section.

Encore Presentation System • User’s Guide • Rev 04 279