6. System Setup

Input Setup

Scroll to the H Position line and set the start of the active area’s horizontal offset from H sync.

Scroll to the V Active line and set the number of vertical lines in the image.

Scroll to the V Position line and set the start of the active area’s vertical offset from V sync.

Press {SAVE} to save the input configuration.

Press {BACK} to return to the Input Menu.

c.If Oversample was selected:

Scroll to the Right Edge line and adjust as required.

Scroll to the Left Edge line and adjust as required.

Scroll to the Top Edge line and adjust as required.

Scroll to the Bottom Edge line and adjust as required.

Press {SAVE} to save the input configuration.

Press {BACK} to return to the Input Menu.

9.Perform additional setups on the Color Balance Menu if required:

a.Press {COLOR BALANCE} to display the Color Balance Menu.

b.If an RGB source was selected:

Scroll to the Red Contrast line and adjust as required.

Scroll to the Red Brightness line and adjust as required.

Scroll to the Green Contrast line and adjust as required.

Scroll to the Green Brightness line and adjust as required.

Scroll to the Blue Contrast line and adjust as required.

Scroll to the Blue Brightness line and adjust as required.

Press {SAVE} to save the input configuration.

Press {BACK} to return to the Input Menu.

c.If a Composite, S-Videoor YPbPr source was selected:

Important

Scroll to the Saturation line and adjust as required. Scroll to the Hue line and adjust as required. Press {SAVE} to save the input configuration. Press {BACK} to return to the Input Menu.

If you have not already performed incremental “saves,” ensure that you press {SAVE} before you exit the Input Menu — otherwise all of your setups will be lost. If you do not save the input, the next time the source is selected, the input’s default settings will be displayed.

In addition, the {SAVE} function performs the Controller’s automatic “Copy Down” feature, which ensures that ImagePRO and PrePRO-II units properly process each input.

10.Repeat from step 4 for the next source that you want to set up.

11.(For non-stack configurations only) When all sources have been set up for the selected destination, press Source Preview to restore the previous setup.

12.Repeat from step 1 for the next destination — only if required. Refer to the “Input Setup Notes” section on page 296 for details.

Encore Presentation System • User’s Guide • Rev 04

 

295

 

Page 295
Image 295
Barco 26-0313000-00 Press Color Balance to display the Color Balance Menu, Encore Presentation System User’s Guide Rev 295