Barco 26-0313000-00 manual TçêâáåÖ=ïáíÜ=íÜÉ=aph

7. Operations

Working with the DSK

tçêâáåÖ=ïáíÜ=íÜÉ=aph

DSK

„Use the following steps to perform a downstream key:

1.Ensure that the DSK is properly set up, and the key "type" is selected on the DSK Input Setup Menu. In Chapter 6, refer to the "DSK Setup" section on page 296 for instructions.

2.Please remember the following important DSK rules:

~For ScreenPRO-II destinations, remember that BG B and the DSK are mutually exclusive.

~For single or wide screen Encore systems using single M/E Video Processors, there are only two DVI input connectors available (1A and 1B). In this configuration, you cannot use both backgrounds and the DSK — you can only use two of the three.

~For stack configurations, remember that DSK sources connect to the “top” stack Processor.

3.In the Layer Control Section, press DSK to display the DSK Adjustment Menu.

4.On the Destination line, select the destination on which you want to perform the downstream key.

~If multiple destinations are active, select the desired destination.

~If a single destination is active, selections cannot be made.

5.On the ID line, select the IDs of the Processor(s) on which you want to perform the downstream key.

~For single screen destinations, ID selections cannot be made.

~For wide screen destinations only, select All to set up all Processors, or select the ID of an individual processor.

6.On the Key Type line, select Luma or Color as required.

7.Adjust DSK parameters, including key type, invert, clip, gain, opacity and fill source. Refer to the "Modifying Keys" section on page 326 for details.

Note

Not all parameters listed in the "Modifying Keys" section apply to a DSK.

8.Perform a CUT or AUTO TRANS.

9.Clear the DSK from Program in the normal manner — by clearing its layer from Preview and then transitioning.

362 Encore Presentation System • User’s Guide • Rev 04