Barco 26-0313000-00 manual see the ScreenPRO-II Destination Setup section for details

3. Hardware Installation

Installation

d.Ensure that all sources are connected to your router(s).

e.Connect all selected router outputs to the desired M/E inputs on VP 1.

9.ScreenPRO-II Connections — if your system includes one (or more) destination ScreenPRO-II units, you can configure them for internal or external routing:

a.When External routers are used, connect two outputs from an Analog router to any two HD-15 inputs on the ScreenPRO-II. An SDI router can also be connected to BNC inputs 1 and 2. During setup, these specific patches will be defined using the Output Patch Menu.

b.When Internal routing is used, connect Analog sources to inputs 1 - 8 on the HD-15 connectors, and SDI sources to BNC inputs 1 and 2. During setup, these patches will be defined using the Input Patch Menu.

In Chapter 6, see the “ScreenPRO-II Destination Setup” section for details.

10.Output Connections —

a.For each VP or VPx, connect the analog or digital Preview Output to the input of the associated Preview Monitor.

b.For each VP or VPx, connect the analog or digital Program 2 Output to the input of the associated Program Monitor.

c.For each VP or VPx, connect the analog or digital Program 1 Output to the input of the associated projector.

d.Connect the Program Out HD/SDI connector to an SDI or HDTV monitor as required, or to the proper video distribution equipment.

Note

This output only works if the selected output resolution is a valid SDI or HD/SDI format.

11.Link Connections — in a widescreen application, the Program Link and Source Link connections (DVI-I) are used to connect processors together, and bridge inputs and outputs for the proper “overlap” between projectors. Refer to the “Program and Source Link Connections” section on page 98 for instructions.

12.Aux Destinations — you can configure three types of Aux destinations: Aux (monitors), ImagePRO Aux and PresentationPRO-II Aux. Refer to Appendix D, “Working With Destinations” on page 393 for interconnection details.

13.Power Connection — connect AC power cords to all Encore and peripheral equipment, and then to AC outlets.

14.Tally Connection — the Controller provides one 25-pin D connector for issuing “relay closure” commands to external devices. Eight circuits are provided. In Appendix A, refer to the “Tally Connector” section on page 374 for details.

15.System ID — Using the Unit ID Selector, set the ID of Processor #1 to 1, Processor #2 to 2, and Processor #3 to 3. Each must have a unique ID. Remember that you can redefine IDs using numbers 17 - 32. In Chapter 5, see the “Miscellaneous Menu” section on page 196 for details.

16.Power On — all power on instructions are covered in Chapter 6.

With all connections made, continue with Chapter 4, “Controller Orientation” on

page 107. Remember that you can create widescreen destinations using processors that do not contain the same number of M/E boards. These procedures are covered in Chapter 6, “System Setup.”

Encore Presentation System • User’s Guide • Rev 04 75