aK==tçêâáåÖ=táíÜ=aÉëíáå~íáçåë

ScreenPRO-II Configurations

fåíÉêå~ä=oçìíÉê=`çåÑáÖìê~íáçå

The diagram below illustrates an Encore configuration that uses two ScreenPRO-II units with internal source routing. Each ScreenPRO-II is set up as a unique destination.

Internal Routing

 

 

ScreenPRO-II

 

 

 

 

 

 

 

 

Analog Inputs 1-8

HD/SD Inputs 1-2

(HD Model Only)

Analog Inputs 1-8

HD/SD Inputs 1-2

(HD Model Only)

Side Screen 1

Side Screen 2

Encore Controller (SC or LC)

Ethernet Switch

Figure D-1.ScreenPRO-II units using internal source routing

For an “internal routing” ScreenPRO-II configuration, please note the following points regarding destination setup and source connections:

On the Destination Setup Menu:

~Select Single Screen SP as the “Type.”

~Set the “Routing Mode” to Internal.

~In Chapter 6, refer to the ScreenPRO-II Destination Setup” section on page 279 for instructions.

Connect analog and digital sources directly to each ScreenPRO-II.

ScreenPRO-II inputs are mapped using the Input Patch Menu:

~If you are using D/As to connect sources to similar inputs on each ScreenPRO-II, select ALL SP as the “Connection Type.”

~If you are connecting to different inputs, separate input patches are required for each.

~In Chapter 6, refer to the “Output Format Setup” section on page 285 for instructions.

394

 

Encore Presentation System • User’s Guide • Rev 04

 

Page 394
Image 394
Barco 26-0313000-00 manual FåíÉêå~ä=oçìíÉê=`çåÑáÖìê~íáçå, Figure D-1.ScreenPRO-II units using internal source routing