Barco 26-0313000-00 manual AL=pÉíìé, Press Router Setup to display the Router Specification Menu

6. System Setup

D/A Setup

aL^=pÉíìé

Encore system setup: Step 8

8	S Prerequisites — Ensure that you are familiar with the following menus:
	~	Router Specification Menu. In Chapter 5, refer to the “Router
		Specification Menu” section on page 190.
	~ Output Patch Menu. In Chapter 5, refer to the “Output Patch Menu”
		section on page 194.
„ Use the following steps to set up a D/A (Distribution Amplifier):
1.	Ensure that the outputs from the analog, SDI or DVI D/A that you wish to set up
	are properly (physically) connected to the desired Video Processor or
	ScreenPRO-II inputs. There are no communications connections required from
	Encore to the D/A.
2.	In the System Keypad, press SYSTEM to display the System Menu.
3.	Press {ROUTER SETUP} to display the Router Specification Menu.
4.	On the Number line, select the number that you wish to assign to the D/A.
	Note
			This is an arbitrary number used for associating the D/A with
			a configuration file. Encore provides an available “pool” of 8
			devices from which you can assign routers and D/As.

5.Press {DELETE ROUTER} to clear any existing specification from memory.

6.On the Router Type line, select the type of D/A that you wish to set up (e.g., D/A SDI, D/A ANALOG). The Number of Inputs line defaults to [1].

7.On the Number of Outputs line, set the number of D/A outputs available.

8.Press {ADD NEW} to save the D/A’s specification.

9.Press {OUTPUT PATCH} to display the Output Patch Menu for the selected D/A.

10.On the Router Output line, select the D/A output that you want to patch.

11.On the Device ID line, select the Video Processor or ScreenPRO-II ID to which you want to patch the selected D/A output.

12.On the VP Input line (or the SP Input line), select the specific Video Processor or ScreenPRO-II input to which you want to patch the selected D/A output.

13.Press {ADD PATCH} to confirm your changes.

14.Repeat steps 10 through 13 for all remaining D/A outputs that you wish to patch.

15.Press {BACK} to return to the Router Specification Menu.

16.Repeat steps 4 through 15 for the next D/A that you wish to assign.

17.In the System Keypad, press SAVE to save the current configuration.

274 Encore Presentation System • User’s Guide • Rev 04