6. System Setup

Output Format Setup

lìíéìí=cçêã~í=pÉíìé

Encore system setup: Step 12

12

S Prerequisites — Ensure that you are familiar with the Output Menu. In

Chapter 5, refer to the “Output Menu Functions” section on page 160.

In this procedure, you will configure the output format for each Video Processor and ScreenPRO-II that is used in your system.

Important Be sure to select your projector’s native resolution and a frame rate that is consistent with your inputs — for example, if you are using 59.94 NTSC video inputs, run the output at the same rate in order to be synchronous.

To guarantee absolute "sync" of Input vs. Output, ensure that you genlock the Video Processors. Refer to the “Genlock Setup” section on page 287 for details.

„ Use the following steps to set up the Encore output format:

1. On the Destination Bus, select the destination that you want to configure.

2. In the System Keypad, press OUTPUT to display the Output Menu. At least one destination must be active in order to access the menu.

3. On the Format line, select the resolution and frame rate at which you want to drive the destination’s projector(s). To minimize synchronization problems, select a frame rate that is consistent with your input sources.

4. Press {APPLY FORMAT} to accept the selection.

5. Repeat from step 2 to set additional destination output formats.

6. In the System Keypad, press SAVE to save the new configuration in memory.

Note

Automatic "Saves" occur as necessary, for example, when you change output resolutions.

Encore Presentation System • User’s Guide • Rev 04

 

285

 

Page 285
Image 285
Barco 26-0313000-00 manual Lìíéìí=cçêã~í=pÉíìé, Encore Presentation System User’s Guide Rev 285