3. Hardware Installation

Installation

4.Source Connections — connect DVI outputs from processors one, two and three to processor #4’s scaler inputs:

~Connect processor #1 DVI Program 2 output to processor #4 input 1A.

~Connect processor #1 DVI Preview 2 output to processor #4 input 1B.

~Connect processor #2 DVI Program 2 output to processor #4 input 2A.

~Connect processor #2 DVI Preview 2 output to processor #4 input 2B.

~Connect processor #3 DVI Program 2 output to processor #4 input 3A.

~Connect processor #3 DVI Preview 2 output to processor #4 input 3B.

Note

Program 2 output is used because it is a clean feed, without

 

any edge feathering or data doubling in the signal.

 

 

5.Output Connections

~Connect processor #4’s analog or digital Preview Output to the input of your widescreen preview monitor.

~(Optional, for video recording) Connect processor #4’s analog or digital Program Output 1 or 2 to the input of the ImagePRO. Connect the ImagePRO’s output to the input of your recorder. Refer to the “ImagePRO User’s Guide” for connection and setup details.

6.Power Connection — connect AC power cords to the AC Power connectors on the rear of processor #4, the monitor and the ImagePRO.

7.System ID — Using the Unit ID Selector, set the ID of processor #4 to 4.

Note

Each processor must have a unique ID.

8.Power On — all power on instructions are covered in Chapter 6.

With all connections made, continue with Chapter 4, Controller Orientation” on page 107.

`çãéäÉíáåÖ=táÇÉ=pÅêÉÉå=mêÉîáÉï=pÉíìé

Once you are familiar with the Controller, all system setup procedures and basic Encore operations, you must complete the following operational setup steps — in order to properly configure processor #4 and its Preview output.

Note

Two different methods are available for connecting processor sources: multi-buttonand single button.

„Multi-button method — Use the following steps to complete your wide screen preview setup, using six individual buttons for processor sources:

1.Set up processor #4 as a unique Encore destination. In Chapter 6, refer to the “Destination Setup” section on page 277.

2.On the Controller, identify six buttons on the Source Selection Bus that you want to use as the inputs from processors 1, 2 and 3.

3.Set up these designated inputs as direct DVI connections. In Chapter 6, refer to the “Input Setup” section on page 293 for details.

78

 

Encore Presentation System • User’s Guide • Rev 04

 

Page 78
Image 78
Barco 26-0313000-00 manual `çãéäÉíáåÖ=táÇÉ=pÅêÉÉå=mêÉîáÉï=pÉíìé, Output Connections