6. System Setup

Background Setup

f.Press {SAVE}.

5.To configure a frame grab background:

a.Ensure that you have captured frame(s) into temporary memory, or saved frame(s) into permanent memory. In Chapter 7, refer to the “Working with Frame Grabs” section on page 355 for instructions.

b.Scroll to the Type line and select one of the three temporary frame stores: FG_1, FG_2 or FG_3.

c.To load a frame from “extended” memory into the selected frame store:

Scroll to the File to load line.

Use the ADJ knob to select a file.

Press {LOAD}.

d.Press {SAVE}.

6.To configure an Analog background:

a.Ensure that your analog source is properly connected to the Video Processor chassis. In Appendix A, refer to the DVI-I Connector Pinouts” section on page 370 for pinout details.

Note

Analog backgrounds cannot be configured on ScreenPRO-II destinations.

b.Scroll to the Type line and select Analog.

c.Set the analog source’s format:

Press {FORCE ACQUIRE}, or ...

To manually set the source’s resolution, select the desired format on the Format line, then press {APPLY FORMAT}.

d.(Optional) Adjust H Offset and V Offset as required.

e.(Optional) Adjust Contrast, Brightness, Sizing and Color Balance as required.

f.Press {SAVE}.

Important

Using analog background in edge-butted mode could possibly cause seams, and is not recommended!

7.Repeat from step 2 for BG B.

8.Repeat from step 1 for the next destination’s background sources.

9.When all background sources have been configured for all destinations, press SAVE in the System Keypad to save the new configuration in memory.

292

 

Encore Presentation System • User’s Guide • Rev 04

 

Page 292
Image 292
Barco 26-0313000-00 manual 292