Encore Presentation System • User’s Guide • Rev 04 265
6. System Setup
Peripheral Power Up and Status Check
açïåäç~ÇáåÖ=`çÇÉ
When an incompatibility exists between software code versions, all buttons will flash on the
Controller console. In this situation, the System Status Menu automatically appears with
the message “Please Upgrade.”
Use the following steps to download code from the Controller to the target device(s),
including Video Processors, ScreenPRO-II units and PresentationPRO-II units:
1. On the Encore Controller console, press SYSTEM > {SW VER} to display the
Software Version Menu. Any incompatibilities will be listed.
Figure 6-2. Software Version Menu (sample)
2. Press {DOWNLOAD CODE} to begin the download process, which takes several
minutes to complete.
During the procedure, several “progress” messages are shown. When the entire
procedure is complete, the Download Code Results Menu displays a summary
of the download. Please note:
~Results may appear on multiple pages.
~If required, press {PG DN} and {PG UP} to move between pages.
~Press {DETAILS} to view additional information for a specific download.
3. After the upgrade process is complete, perform a complete factory reset on the
Controller and any Processors and/or ScreenPRO-IIs that the Controller detects.
Refer to the “Return to Factory Default” section on page266 for instructions.
At the conclusion of the procedure, each Video Processor, ScreenPRO-II, and
PresentationPRO-II is running the same version of code as the Encore Controller.
B
A
C
K
N
A
V
A
D
J
SOFTWARE VERSION
Controller 1.10
DOWNLOAD
CODE
VP 1: 1.10 VP 2: 1.10
VP 3: 1.10 VP 4: 1.00
SP 5: 1.00
FORCE
DOWNLOAD
Software version mismatch!
Download device(s) software
Software versions
incompatible with
Controller’s version