Encore Presentation System • User’s Guide • Rev 04 137
4. Controller Orientation
Controller Sections
dêçìé=`çåíêçä=pÉÅíáçå
The figures below illustrate the Group Control Section on each Controller. The sections
are essentially identical, except that the Controller SC has fewer group buttons.
Figure 4-21. Group Control Section, Controller SC
Figure 4-22. Group Control Section, Controller LC
A single “group” button can be programmed to represent one or more destinations. This
feature simplifies the method by which you activate destinations. Descriptions of each
button are provided below.
Group Buttons — four groups are available on the Controller SC; eight on the Controller
LC. Any combination of Group buttons can be enabled, but all group selections (whether
individual or multiple) are mutually exclusive.
Press a numbered Group button by itself to enable the assigned destination(s)
and toggle all other groups (and destinations) off. When pressed, the assigned
destination buttons immediately light on the Destination Bus.
Press two or more Group buttons simultaneously to enable multiple groups of
destinations (e.g., Groups 1, 3 and 4), and toggle all other active groups (and
destinations) off.
All — (Controller LC only)
Press All to activate (enable) all assigned groups of destinations.
On the Controller SC, you must simultaneously press all assigned Group buttons
to perform the “all enable” function.
Clear — (Controller LC only)
Press Clear + a selected Group button to clear that one group only.
Press Clear + ALL to clear all active groups.
On the Controller SC, there are two ways to clear a group:
~Press the group(s) that you wish to remain enabled (which will, in turn,
clear the other un-selected groups).
~Press and hold the Clear button (on the Destination Bus), then press
the button(s) for the destination(s) that you wish to clear.
Group
2Group
3Group
4
Group
1
GROUPS
Group
7Group
8All Clear
Group
2Group
3Group
4Group
5Group
6
Group
1
GROUPS
Learn

Group

1

All

Clear