CLI commands

snmp-server trap destination

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422

snmp-server trap destination <host> <[port number]>

Add a new trap destination.

no snmp-server trap destination <host> [<port>]

Deletes the specified trap destination.

Parameters

<host>

 

Sets the IP address or domain name of the host that the AP will send traps

 

 

to.

<[port

number]>

SNMP port number. Range 1 - 65535. By default port 162 is used

snmp-server trap heartbeat

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422

snmp-server trap heartbeat

Enables sending of heartbeat traps at regular intervals.

no snmp-server trap heartbeat

Disables sending of heartbeat traps at regular intervals.

snmp-server trap link-state

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422

snmp-server trap link-state

Send a trap when the link state changes on any interface.

no snmp-server trap link-state

Do not send this trap.

snmp-server trap snmp-authentication

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422

snmp-server trap snmp-authentication

Send a trap each time an SNMP request fails to supply the correct community name.

snmp-server version 1

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422

snmp-server version 1

Enable version 1

no snmp-server version 1

Disable version 1

2-22