CLI commands

This is a global setting that is useful when creating wireless links to remote sites. However, it also applies to all wireless connection made with the radio, not just for wireless links. Therefore, if you are also using the radio to serve local wireless client stations, adjusting this setting may lower the performance for clients with marginal signal strength or when interference is present.

(Essentially, it means that if a frame needs to be retransmitted it will take longer before the actual retransmit takes place.)

dot11 mode

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422

dot11 mode (monitor ap+wds ap-only wds-only sensor)

Sets the operating mode for the radio.

spectralink view

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422

spectralink view

Enable the use of spectralink view.

no spectralink view

Disable the use of spectralink view.

dot11n channel extension

Supported on: MSM410 MSM422

dot11n channel extension (above below)

Select the 802.11n channel extension. Applicable only in the 2.4 GHz band with a 40 MHz channel width.

dot11n channel width

Supported on: MSM410 MSM422

dot11n channel width (40 20 auto)

Select the 802.11n channel width.

dot11n guard interval

Supported on: MSM410 MSM422

dot11n guard interval (short long)

Select the 802.11n guard interval.

dot11n multicast rate

Supported on: MSM410 MSM422

dot11n multicast rate <rate>

Set the multicast rate for use with 802.11n networks.

2-52