CLI commands

delete ip filter

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422

delete ip filter <ip address>/<mask>

Deletes the specified address from the IP filter list.

If the list is empty, then all wireless-to-wired LAN traffic is permitted.

Where:

 

<address>

IP address.

</mask>

Subnet mask in CIDR format. Specifies the number of bits in the mask.

delete ip filter all

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422

delete ip filter all

Deletes all addresses from the IP filter list.

ip filters

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422

ip filters

Activates the IP filter which enables you to block wireless-to-wired LAN traffic on this profile based on its destination address.

no ip filters

Disables the IP filter for this profile.

active

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422

active

Enable this VAP (VSC).

no active

Disable this VAP (VSC).

beacon dtim count

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422

beacon dtim count <number>

Defines the DTIM period in the beacon.

Client stations use the DTIM to wake up from low-power mode to receive multicast traffic. The AP transmits a beacon every 100 ms. The DTIM counts down with each beacon that is sent, therefore if the DTIM is set to 5, then client stations in low-power mode will wake up every 500 ms (.5 second) to receive multicast traffic.

2-62