5.Press and hold down the latch to disconnect the power cable (1) and data cable (2) from the back of the hard drive.

Figure 7-37Disconnecting the Hard Drive Power Cable and Data Cable

6.Press down on the green release latch next to the hard drive (1). While holding the latch down, slide the drive forward until it stops, then lift the drive up and out of the bay (2).

Figure 7-38Removing the Hard Drive

7.To install a hard drive, you must transfer the silver and blue isolation mounting screws from the old hard drive to the new hard drive.

Figure 7-39Installing Hard Drive Mounting Screws

78 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis

Page 86
Image 86
HP Pro 4300 manual