Front I/O, Power Switch Assembly

Description

Spare part number

 

 

Front I/O and power switch assembly

636926-001

 

 

The front I/O and power switch/LEDs are one assembly, attached to the front of the chassis. Push the assembly into the chassis to remove.

1.Prepare the computer for disassembly (Preparation for Disassembly on page 48).

2.Remove the access panel (Computer Access Panel on page 50).

3.Remove the front bezel (Front Bezel on page 51).

4.Remove the chassis fan (Front Fan Assembly on page 81).

5.Rotate the drive cage to its upright position.

6.Disconnect the four cables from the system board as follows:

Yellow connector labeled FRONT USB1

Green connector labeled FRONT USB2

Blue connector labeled FRONT AUD

Black connector labeled PB/LED

7.Remove the screw that secures the assembly to the front of the chassis. Figure 7-44Removing the front I/O, power switch/LED assembly screw

82 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis

Page 90
Image 90
HP Pro 4300 manual Front I/O, Power Switch Assembly, Remove the chassis fan Front Fan Assembly on