"/.sw/sessions/swverify.last".

*The analysis phase succeeded for

"my_system:/my_depots/new_directory_depot".

*Verification succeeded.

NOTE: More information may be found in the agent logfile using the command "swjob -a log my_system-0831 @ my_system:/my_depots/new_directory_depot".

======= 05/03/04 12:28:51 MDT END swverify SESSION (non-interactive) (jobid=my_system-0831)

The following example verifies the directory depot /my_depots/PHSS_30278_depot/. This depot contains one patch, PHSS_30278. This patch is dependent on patch PHSS_29657, which is not included in the depot. Because of this, the verification failed. The command output indicates how you can obtain more information about the failure. In this case, if patch PHSS_29657 is already installed on the target system, you can use depot PHSS_30278_depot for installation of patch PHSS_30278, even though the depot failed verification.

For example:

$ swverify -d \* @ /my_depots/PHSS_30278_depot

======= 05/03/04 13:04:00 MDT BEGIN swverify SESSION (non-interactive) (jobid=my_system-0841)

*Session started for user "some_user@my_system".

*Beginning Selection

*Target connection succeeded for

"my_system:/my_depots/PHSS_30278_depot".

NOTE: The software "PHSS_30278" was successfully marked, but it depends on the following software items which could not be found in the source. However, these items may already be in the target. This will be checked during the Analysis Phase: PHSS_29657.LANG-AUX,fa=HP-UX_B.11.23_IA

*Software selections:

PHSS_30278.F90-JPN-E-MAN,r=1.0,a=HP-UX_B.11.23_IA/PA, v=HP,fr=1.0, fa=HP-UX_B.11.23_IA/PA PHSS_30278.F90-JPN-S-MAN,r=1.0,a=HP-UX_B.11.23_IA/PA, v=HP,fr=1.0, fa=HP-UX_B.11.23_IA/PA PHSS_30278.F90-RELNOTES,r=1.0,a=HP-UX_B.11.23_IA/PA, v=HP,fr=1.0, fa=HP-UX_B.11.23_IA PHSS_30278.FORT90-MAN,r=1.0,a=HP-UX_B.11.23_IA/PA, v=HP,fr=1.0, fa=HP-UX_B.11.23_IA/PA PHSS_30278.FORT90-PRG,r=1.0,a=HP-UX_B.11.23_IA/PA, v=HP,fr=1.0, fa=HP-UX_B.11.23_IA

*Selection succeeded.

*Beginning Analysis

*Session selections have been saved in the file "/.sw/sessions/swverify.last".

ERROR: "my_system:/my_depots/PHSS_30278_depot": The software dependencies for 1 products or filesets cannot be resolved.

*The analysis phase failed for

"my_system:/my_depots/PHSS_30278_depot".

*Verification had errors.

NOTE: More information may be found in the agent logfile using the command "swjob -a log my_system-0841 @ my_system:/my_depots/PHSS_30278_depot".

======= 05/03/04 13:04:01 MDT END swverify SESSION (non-interactive) (jobid=my_system-0841)

Removing software from a directory depot

If you need to remove patches from a directory depot, you can do so by using the swremove command.

74 Using software depots for patch management