HP UX System Management Software manual See Software Distributor

registered client	A client system that has its MAC address registered with the server in order to always boot to the
	same assigned IP address. For PA-RISC systems, the client’s MAC address is assigned to an IP
	address in the /etc/opt/ignite/instl_boottab or /etc/bootptab file. For Itanium-based
	systems, the default is to use the /etc/bootptab file. Contrast with anonymous client.
required	With 11i v3, software and network driver bundles that are required and always installed with
	HP-UX. Software in this category cannot be deselected.
S
save_config	An Ignite-UX command that creates a hardware configuration file. It extracts disk and file system
	information along with certain system and networking parameters for the current system, and
	writes it to a configuration file. See save_config(1M).
script hook	Predefined mechanisms allowing user-defined scripts to run at specific points during the execution
	of the installation. Within the Ignite-UX installation procedure there are various script hooks:
	pre-config, pre-load, post-load, post-config, and final. See instl_adm(4) under “Command and
	Script Execution Hooks.”
SCRIPTS	A configuration clause of commands in the LIF volume containing scripts that can be selected in
	the itool under the Advanced tab.
SD-UX	See Software Distributor.
selectable	For 11i v1 and 11i v2, software bundles that are not installed by default with HP-UX. You must
	select these bundles to install them. Ignite-UX is an example of a selectable software bundle.
server	A computer that provides software and services to clients.
server selection	The ability of a client system to request DHCP/bootp boot services from a specific boot server
	and ignore all other boot offers. Client networking configuration information is supplied by the
	boot server.
setup_server	An Ignite-UX command that performs administration tasks for an Ignite-UX server from a command
	line interface. The same functionality is available with the Ignite-UX GUI. See setup_server(1M).
Software Depot	See depot.
Software	An HP-UX product that provides a set of tools for centralized HP-UX software management.
Distributor	Software Distributor (SD-UX) commands are included with the installation of the HP-UX operating
	system. SD-UX commands typically use the prefix “sw”, such as in swinstall and swverify.
stand alone	In terms of Ignite-UX (as opposed to any other usage) a client system that is not network booted,
	but may still use an Ignite-UX server for installation or recovery.
standard label	A tape containing ANSI standard labeling. Ignite-UX uses ansitape(1) to create a standard label
tape	tape.
subnet	A separate part of a larger network connected via network gateways.
SWAP	A use designation typically for an logical volume manager (LVM) logical volume or a VxVM
	volume for paging. See swapon(1M).
SWAP+DUMP	A use designation typically for an logical volume manager (LVM) logical volume or a VxVM
	volume that can be used for DUMP or SWAP.
SYSCMDS	A compressed tar archive of commands in the LIF volume or on an Ignite-UX server, required
	for installation of PA-RISC systems.
SYSCMDSIA	A compressed tar archive of commands in the LIF volume or on an Ignite-UX server, required
	for installation of Itanium-based systems.
system image	See image.
system recovery	The use of a recovery image to reestablish a system.
T
two-step media	A method of using the Ignite-UX tape recovery tool when a system or I/O interface does not
recovery	support firmware tape boot. The method involves step 1: booting from installation media such as
	DVD or CD, and then step 2: recovering from tape.

265