HTC RAPH800 manual Using Your Device’s Battery and Charger, Installing and Removing the Battery

Using Your Device’s Battery and Charger

Your device is equipped with a Lithium Ion (Li-Ion) battery. It allows you to recharge your battery before it is fully drained. The battery provides up to 4.2 hours of continuous digital talk time.

Note	•	Long backlight settings, searching for service, vibrate mode, browser use, and other variables may reduce the
		battery’s talk and standby times.
	•	Watch your device’s battery level indicator and charge the battery before it runs out of power.

If you need to purchase extra batteries for your device, Sprint-approved or HTC-approved batteries and accessories can be found at Sprint Stores or through HTC; or call 1-866-343-1114to order. They’re also available at www.sprint.com.

WARNING Use only Sprint-approved or HTC-approved batteries and chargers with your device. The failure to use a Sprint-approved or HTC-approved battery and charger may increase the risk that your device will overheat, catch fire, or explode, resulting in serious bodily injury, death, or property damage.

To reduce risk of fire or burns:

•Do not attempt to open, disassemble, or service the battery pack.

•Do not crush, puncture, short external contacts, or dispose of in fire or water.

•Do not expose to temperatures above 60oC (140oF).

•Replace only with the battery pack designated for this product.

•Recycle or dispose of used battery as stipulated by local regulations.

Installing and Removing the Battery

Always turn off your device before installing or replacing the battery. You also need to remove the back cover before you can install these components.

To install the battery:

See “Setting Up Your Smart Device” on page 2.

To remove the battery:

1.Make sure your device is turned off.

2.Remove the back cover.

3.The bottom right side of the battery has a protruding grip. Lift the protruding grip to remove the battery.

Battery grip

Device Basics

Section 2A. Device Basics 15