Print Server Administration User’s Guide
arp
For example, to assign the address 202.39.74.40 to the print server with MAC address 00 80 C8 14 26 34, use the command:
arp
Note: on a
3.From the host with the modified ARP table, send an ICMP echo request to the print server using the ping command:
ping 202.39.74.40
When the print server receives an ICMP request at its own Ethernet address, but with a different IP address than the one it was expecting, it changes its IP address setting.
4.The print server will now respond to the new IP address. At this point you can use the telnet interface (as described below) to change the host’s other settings.
Accessing the Telnet Interface
You can access your print server’s telnet interface using an ordinary telnet client program. On many systems, the command to invoke a telnet client is:
telnet
Where
When you first telnet to the print server, it displays its
The print server will then display the telnet interface main menu:
[Main Menu]
1 - Server Configuration
2 - Port Configuration
3 - TCP/IP Configuration
4 - AppleTalk Configuration
5 - Display Information
6 - Tools
7 - Save Configuration
0 - Quit
Enter Selection:
Changing TCP/IP Settings
Once you have set the print server’s IP address for the first time (using the method described above), you may wish to change the address or other TCP/IP configuration information such as the local network mask, the default gateway, the accepted
EtherP Admin Administration | 65 |
