IBM 28L2234 manual Installing, drive, Setting, jumpers, Step

Installing

the

drive

The

instructions

in

this

section

are

general

guidelines

that

apply

to

most

computers.

For

specific

information

on

installing

a

drive

in

your

computer,

see

the documentation

that

comes

with your

computer.

Step

1.

Opening

the

computer

1. Turn

off

the

computer

and

all

attached

devices.

2.

Unplug

from

the

electrical

outlets

all

cables

for

your

computer

and

attached

devices.

It is now safe to open your computer.

For specific information about opening your computer, see the documentation that comes with your computer.

3.

Before

handling

the

drive,

ground

yourself

by

touching

an

unpainted

surface

on

the

computer.

Ground

yourself

again

after

leaving

and

returning

to

your

work

area.

4.

Always

handle

the

drive

by its edges. Do not touch

any

exposed

printed

circuitry,

components,

or

connector

pins.

5.

While

installing

the

drive,

avoid

all

unnecessary

handling.

Rough

handling

can

damage

the

components

inside

the

drive

housing.

6.

If

you

must

put

the

drive

down,

place

the

antistatic

bag

on a flat

padded

surface,

such

as

a magazine,

and

place

the

drive

on the

bag.

Step	3.	Setting		the	configuration	jumpers
You	can configure		your	drive	as Master	1 , Slave 2 , or Cable
Select	3 ,		as shown.

Step

2.

Unpacking

the

drive

Follow

these

steps

when

you

unpack

the

drive.

1.

Do

not

open

the

antistatic

bag

until

you

are

ready

to

install the

drive. Static electricity can damage the drive

and

other

computer

components.

2.

Touch

your

hand

and

the

inner

conductive

surface

of

the

antistatic

bag

containing

the drive

to

an

unpainted

metal

surface on

the

computer for

two

seconds.

This

drains static

electricity

from

the

bag

and

your body.

1-4 IBM 2X/4X/24X CD-ReWritable Internal IDE Option Kit