Removing a bridge card:
Attention: Before removing the EXP300 bridge card, you must turn off the expansion unit. Refer to “Turning the expansion unit on and off” on page 3 for detailed instructions.
Complete the following steps to remove the EXP300 bridge card:
1.Turn off the expansion unit. Refer to “Turning the expansion unit on and off” on page 3.
2.Remove the drive CRUs or blank filler panels from the left and right of the bridge card bay. Refer to “Replacing
3.Squeeze the
4.Lift the tray handle Þ Ý, and pull the tray Þ Ý that contains the bridge card out of the bridge card bay.
Installing a bridge card:
Attention: Make sure the expansion unit is turned off before installing a bridge card. Refer to “Turning the expansion unit on and off” on page 3.
Complete the following steps to install the EXP300 bridge card:
1.Make sure the expansion unit is turned off.
2.Hold the bridge card tray Þ Ý so the tray handle Þ Ý is at the top of the bridge card tray and pointing outward.
3.Slide the tray Þ Ý that contains the bridge card into the bridge card bay.
4.Push the tray handle Þ Ý down, locking the
5.Replace the bridge card cover Þ Ý by squeezing each of the four tabs, locking the cover into place.
6.Turn on the expansion unit. Refer to “Turning the expansion unit on and off” on page 3.
Replacing the switch card
To replace the switch card CRU in the EXP300 expansion unit, follow the instructions for removing the switch card and installing the switch card.
Removing the switch card:
Attention: Before removing the switch card, be sure to turn off the expansion unit. Refer to “Turning the expansion unit on and off” on page 3. Make note of the switch card settings so you can set the new card to the same settings. Failure to do so will result in loss of data.
Netfinity EXP300 Type 3531 23
