
EasyCoder 3400e Bar Code Label Printer User’s Manual
12.Secure the media to the rewinder hub by snapping the rewinder clasp onto the rewinder hub. Turn the rewinder hub clockwise to remove all slack from the media liner between the tear bar and the rewinder hub.
13.Close the media access door.
14.Rotate the head lift lever counterclockwise until it locks.
15.Use PrintSet, your
16.Press the Feed/Pause button to advance a label through the printer. Grasp the leading edge of the label where it has separated from the backing and pull it away from the printer.
17.Replace the printer cover. The printer is now ready to print labels.
Loading Thermal Transfer Ribbon
If you plan to use thermal transfer mode, you must install a thermal transfer ribbon (TTR) to print in thermal transfer mode.
Note: Save the packaging that your ribbon came in. Attached to the ribbon packaging is a small label with a
To load thermal transfer ribbon
1.Raise the printhead by rotating the head lift lever clockwise until the printhead disengages.
2.Place the empty ribbon core that came with the printer onto the ribbon rewind hub.
3.Detach the leader from the new thermal transfer ribbon roll and unwind the end of the ribbon approximately 20.32 centimeters (8 inches). The edge of the ribbon has a leader (with an adhesive strip on the leader edge) for guiding the ribbon through the printhead mechanism.
4.Slide the roll of thermal transfer ribbon onto the ribbon supply hub with the ribbon roll winding clockwise.