IBM EasyCoder 3400e user manual To set the Y forms adjust

EasyCoder 3400e Bar Code Label Printer User’s Manual

5.Press the Feed/Pause button.

The printer prints out the software configuration label using the new X forms adjust setting.

6.Verify the X forms adjust number on the software configuration label matches the number you set in Step 4.

Y Forms Adjust

Use the Y Forms Adjust feature to control the position of the image in the direction parallel to the printhead. See the Dot Increments DIP Switch Settings table on page 6-8 for information on how to move the image forward a number of dot increments. If your label is too close to one edge of the printhead, you can adjust it using this feature.

To set the Y forms adjust

1.Turn the On/Off switch to the off position.

2.Press and hold the Feed/Pause button while turning on the printer.

The printer prints out the hardware configuration label and then enters Data Line Print mode.

3.In the top bank of the Test and Service DIP switches, turn on switches 1, 2, and 3.

4.In the bottom bank of the Test and Service DIP switches, turn on or off the appropriate DIP switches. See the Dot Increments DIP Switch Settings table on page 6-8 to see how to set the X forms adjust forward or backward a given number of increments.

5.Press the Feed/Pause button. The printer prints out the software configuration label using the new Y forms adjust setting.

6.Verify the Y forms adjust number on the software configuration label matches the number you set in Step 4.

6-14