Power system checkout
To verify a symptom, do the following:
1.Turn off the computer.
2.Remove the battery pack.
3.Connect the ac power adapter.
4.Check that power is supplied when you turn on the computer.
5.Turn off the computer.
6.Disconnect the ac power adapter and install the charged battery pack.
7.Check that the battery pack supplies power when you turn on the computer.
If you suspect a power problem, see the appropriate one of the following power supply checkouts:
•“Checking the ac power adapter” on page 33
•“Checking operational charging” on page 33
•“Checking the battery pack” on page 34
•“Checking the backup battery” on page 34
Checking the ac power adapter
You are here because the computer fails only when the ac power adapter is used.
•If the power problem occurs only when the docking station or the port replicator is used, replace the docking station or the port replicator.
•If the
•If the computer does not charge during operation, go to “Checking operational charging” on page 33.
To check the ac power adapter, do the following:
1.Unplug the ac power adapter cable from the computer.
2.Measure the output voltage at the plug of the ac power adapter cable. See the following figure:
3
2
1
(20V)
Pin | Voltage (V dc) |
1+20
20
3Ground
Note: Output voltage of pin no.2 of the ac power adapter may different from the one you are servicing.
3.If the voltage is not correct, replace the ac power adapter.
4.If the voltage is acceptable, do the following:
•Replace the system board.
•If the problem persists, go to “FRU tests” on page 31.
Note: Noise from the ac power adapter does not always indicate a defect.
Checking operational charging
To check whether the battery charges properly during operation, use a discharged battery pack or a battery pack that has less than 50% of the total power remaining when installed in the computer.
Chapter 3. General checkout 33
